Lippert-components Ground Control 3.0 Manuale Utente Scaricare il pdf (Pagina 14)

Rev: 01.30.2015

Page 14

Ground Control 3.0 Service Manual

Fig. 21

5. Remove the screws (Fig. 21A) from the rear sensor (Fig. 21B) and mounting plate (Fig. 21C) and remove

the sensor from the plate.

6. Dry fit the mounting plate (Fig. 22A) and the replacement rear sensor (Fig. 22B) to the crossmember

(Fig. 22C). The pre-drilled holes in the plate are for mounting the rear sensor to the plate. Mark on the

plate where the rear sensor will set. Space between the sensor and the crossmember MUST be left so

the wire harness will not be pinched.

Fig. 22

Front

Rear

Front

Rear

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 25 26

Nessun commento

Lippert-components Ground Control 3.0 Manuale Utente Pagina 14